Railing

 

  1. ToolUse general woodworking tools, electric drill、self drill、countersink、sawing machine….

  2. Cutting processWoodworking cutter speed is about 3600RPM. It needs to use tungsten carbide saw blade which diameter is 10 ~ 12" and sawtooth is 36 ~ 42 teeth, the less tooth of the blade, the easier for the machine to cut-off and discharge residue. When processing, you can spray anti rust oil (WD-40) on the saw blade to avoid crumbs with sticky.

  3. Burrs repairYou can use fine sandpaper, knives or scissors to grind or scrape for cutting off the burrs.

  4. PillarUse the 100x100 square column and the interval between the pillar is around 1m to 1.5m with specific fixed foot. Using the M8×5”screw and nut to fix the square column, then using  expansion screws fixed on the ground 【See the picture below】When fixing the screws, you also can use the plastic cap to hide the screws and nuts. 
  5. LatticeUse the 100x40 board and the interval between each one is around 15-20cm.【See the picture above】
  6. Lattice beamUse 100x40 board as a beam to fix the lattice with #10 x 2-1/2 in., the diameter of 4.8 mm screw.

  7. MaintenanceWipe it with water or wood floor cleaner.

  8. Rail construction tools as below picture
   Wood screw        Tapping screw       saw blade       saw blade     Electric drill