Tool: Use general woodworking tools, electric drill, self drill, countersink, sawing machine…
Cutting process: Woodworking cutter speed is about 3600RPM. It needs to use tungsten carbide saw blade which diameter is 10" ~ 12" and saw tooth is 36 ~ 42 teeth, the less tooth of the blade, the easier for the machine to cut-off and discharge residue. When processing, you can spray anti rust oil (WD-40) on the saw blade to avoid crumbs with sticky.
Burrs repair: You can use fine sandpaper, knives or scissors to grind or scrape for cutting off the burrs.
Maintenance: Wipe it with water or wood floor cleaner.
Fasteners floor fixed method：
Need to use screws, do not use nail gun or nails to fix. Steel structure base with tapping screw, decking foundation use wood screws; Screw specifications for #8 (diameter is about 4.2 mm), the length of the screw should be 2-3 cm longer than fastener; It needs two pieces of fasteners to fix at connection of boards. Also, it needs to be left 2-3 mm gap in winter, but without the gap in summer.
Fence fixed method：
Use tapping screw. Drill hole with 5mm self-drilling first, and then use screws which is #10, the diameter is about 4.8 mm. The length of screw needs to be 2-3 cm longer than wallboard and it can’t be fixed with nail gun or iron nail.
Rail fixed method：
Use the 100x100 square column and the interval between the pillar is around 1m to 1.5m with specific fixed foot. Using the M8×5”screw and nut to fix the square column, then using expansion screws fixed on the ground 【See the picture below】When fixing the screws, you also can use the plastic cap to hide the screws and nuts.
