1. ToolUse general woodworking tools, electric drill, self drill, countersink, sawing machine…

  2. Cutting processWoodworking cutter speed is about 3600RPM. It needs to use tungsten carbide saw blade which diameter is 10" ~ 12" and saw tooth is 36 ~ 42 teeth, the less tooth of the blade, the easier for the machine to cut-off and discharge residue. When processing, you can spray anti rust oil (WD-40) on the saw blade to avoid crumbs with sticky.

  3. Burrs repairYou can use fine sandpaper, knives or scissors to grind or scrape for cutting off the burrs.

  4. Column and crossbeamUsing steel structure is the best. The interval between the pillar is about 1 m to 1.5 m, and the interval between the crossbeam is around 50 cm.

  5. Fence fixed method: Use tapping screw. Drill hole with 5 mm self-drilling first, and then use screws which is #10, the diameter is about 4.8 mm. The length of screw needs to be 2-3 cm longer than wallboard and it can’t be fixed with nail gun or iron nail. (See the picture above)

  6. Maintenance: Wipe it with water or wood floor cleaner.

  7. Fence construction tools as below picture:
   Wood screw        Tapping screw       saw blade       saw blade     Electric drill